May 12, 2024
The filling and sealing machine is used to seal plastic pipes. Its functions and uses have been listed in detail in the past. The filling and sealing machine can seal various pastes, pastes, viscosity fluids, etc. The material is injected into the hose smoothly and accurately, and the hot air heating, tail sealing and batch number, production date, etc. in the tube are completed. It is suitable for filling and sealing large-diameter plastic pipes and composite pipes in the pharmaceutical, food, cosmetics, daily chemicals and other industries. Then we may have some malfunctions when using the filling and sealing machine for a long time. What should we do if we encounter it?
1: When edge locking occurs, it is usually caused by excessive temperature. At this time, you should check whether the actual temperature is the temperature required for normal operation of the hose of this specification. The actual temperature on the temperature display should be relatively stable from the set temperature (normal deviation range is between 1°C and 3°C).
2: If there is an ear on one side: first check whether the heating head is correctly placed in the heating head nest; then check the verticality of the heating head and the hose below. Another possible reason for the phenomenon of ears on one side is that the tail is clamped between two pieces.
3: The tail seal begins to crack from the middle of the hose. If this phenomenon occurs, the heating head is not large enough. Please replace it with a larger heating head. The criterion for judging the size of the heating head is to insert the heating head into the hose and then pull it out. You will feel a slight suction when pulling it out.
4: "Eyebags" appear under the explosion-proof line of the tail seal: This situation occurs because the height of the air outlet of the heating head is incorrect, and it can be adjusted as follows.
5: The hose is cut and dented in the middle of the tail: This problem is usually caused by the wrong size of the tube cup.
Previous: How to quickly address a ball mill blockage?
Next: What should you do when the filling and sealing machine fails?
