Nov 25, 2020
An electric contact pressure gauge is installed at the material inlet on the grinding chamber tomonitor the working pressure inside the cylinder, and an electrical contact temperature gauge is supplied in the discharge port to monitor the temperature of the products. The pressure and temperature control points are set before delivery from the manufacturer (0.15~0.25Mpa, 60~70℃), and can reset according by the user. Setting method: Use a flat-blade screwdriver to insert a shift fork in the center of the watch, make the shift fork to adjust the red needle in the watch, and make the red needle point to the required pressure value and temperature value.
www.mixerbeadmill.com
