Jan 29, 2025
1. Poor dispersion effect
Reason:
Disperser disc is worn or improperly installed.
Incorrect speed setting.
Material viscosity is too high or too low.
Solution:
Check and replace worn disperser disc.
Adjust speed to appropriate range.
Adjust material viscosity to ensure it is within appropriate range.
2. Excessive vibration or noise of equipment
Reason:
Disperser disc or impeller is unbalanced.
Worn or loose bearings.
Insufficient installation.
Solution:
Check and correct the balance of the disperser disc or impeller.
Replace worn bearings.
Ensure that the equipment is securely installed.
3. Hydraulic system failure
Reason:
Insufficient or contaminated hydraulic oil.
Leaking hydraulic cylinder or seal.
Solution:
Check and replenish hydraulic oil.
Replace leaking hydraulic cylinder or seal.
4. Electrical system failure
Reason:
Loose or damaged wires or cables.
Motor failure.
Control panel failure.
Solution:
Check and repair loose or damaged wires.
Replace the faulty motor.
Replace the control panel.
Previous: How to quickly address a ball mill blockage?
Next: What parts do you need to check before operating a High speed disperser?
